1. Download the BIOSR216_98.EXE file to a temporary or download directory (please note this directory for reference).
2. Go to the directory where the file was downloaded and double click the BIOSR216_98.EXE file. The file will extract to the C:WINDOWSTEMPBIOS_Version_R2.16 directory.
3. Click OK.
4. Click Next.
5. Place an empty formatted floppy disk into the floppy A: drive.
6. Go to the C:WindowsTempBios_Version_R2.16 directory.
7. Double click the INSTALL.BAT file.
8. System files and BIOS R2.16 files will be copied to the floppy disk.
9. When prompted, leave the floppy disk in the floppy A: drive, close all windows and restart the computer.
10. The install program will automatically update the BIOS and shut the computer off.
11. Remove the floppy disk and start the computer again.

NOTE: If a checksum error occurs, please press F2 to enter BIOS setup. In the BIOS setup screen, RIGHT-ARROW over to EXIT, highlight EXIT (Save Changes) and press ENTER twice to restart the computer.
12. Label the floppy disk "BIOS R2.16" and save it. It can be used to restore this BIOS should the need arise.

After the computer restarts, the upgrade to the BIOS Version 2.16 is complete.

NOTE: To confirm installation of the new BIOS, do the following:

1. Click Start, point to Tool Center, and click Sony Notebook Setup.
2. Click the "About This Computer" tab. The BIOS Version should indicate R0216S1.

This utility will update the system BIOS for compatibility with the Microsoft® Windows® 98 operating system and resolves the issue where the notebook does not resume from the Hibernate or Suspend Mode.

• Before installing this update, be sure the computer is running from AC power. If the installation of the BIOS is interrupted by power loss, the computer may not operate correctly or at all!
• To install this upgrade, the floppy drive will need to be installed in the computer. You will also need to create a bootable floppy disk to receive the BIOS update files. To prepare a floppy disk for use with this update, please refer to the Create A Bootable Floppy Disk procedure.
• To ensure that no other program interferes with the installation, save all work and close all other programs. The Taskbar should be clear of applications before proceeding.
• It is highly recommended to print out these instructions and the "NT Drivers install.txt" file that will appear as a reference during the installation process.